iRide Technologies

Your Shopping Cart

Show Cart
Your Cart is currently empty.
You are here:
OBD-II Scantools arrow HEX USB + CAN for VAG-COM 908



HEX USB + CAN for VAG-COM 908

Price:  Call for Pricing excluding VAT
Price:  Call for Pricing including VAT


 

The HEX-USB+CAN is an Intelligent Dual-K plus CAN <-> USB Interface compaitable with Ross Tech's VAG COM v908.  This interface works with all diagnostic-capable VW, Audi, Seat, and Skoda models from 1990 through 2010.

 The HEX-USB+CAN when coupled with VAG COM v908 software offers the following features,

  • Full compatible with all VW, Audi, Seat and Skoda models through 2009, including models using a direct CAN connection for diagnostics 
  • Switch off Check Engine light (MIL)
  • View live engine sensors such as Engine RPM, Calculated Load Value, Coolant Temperature, Fuel System Status, Vehicle Speed, Short Term Fuel Trim, Long Term Fuel Trim, Intake Manifold Pressure, Timing Advance, Intake Air Temperature, Air Flow Rate, Absolute Throttle Position, Oxygen sensor voltages/associated short term fuel trims, Fuel System status, Fuel Pressure an lots more
  • Read, Display and Clear Engine fault codes (Diagnostic Trouble Codes) - both stored codes and pending codes
  • Access all control modules which require proprietary VAG modes running the KWP-2000 protocols (2001+ Teves Mk.60 ABS, numerous 2002+ modules), KWP6000 (CAN) and/or KWP7000 (UDS)
  • Database of more than 12000 fault-codes and measuring-block texts.
  • Use the new 7-Digit PIN/SKC codes to match new keys in all immobilizer equipped VW/Audi/Seat/Skoda models.
  • Allows you to view,  log, and graph 3 groups of Measuring Blocks at once
  • Can use the new 7-Digit PIN/SKC codes to match new keys in all immobilizer equipped VW/Audi/Seat/Skoda models.

 Advanced Features possible without any hardware change :

  • Enable Outer Rear View Mirror heating
  • Enable Coming home and Leaving home Lights feature 
  • Enable both Rear fog lights by default
  • Anti-theft activation
  • Change remote locking/unlocking can be changed to blink+honk or just honk. Default is just blink
  • Change volume and interval of parktronic beeps
  • Reset Service Interval Light

Scope of Supply :

  •  HEX USB + CAN Diagnostic Interface Cable ( VAG COM  software not included )
  • Driver CD

Ross Tech's VAG COM v908.2 can be found here !


Availability

In Stock: Yes, Limited Availability
                  24h.gif

Usually ships in:

24h.gif